Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Option settings
Use the F and G buttons on the
projector or remote control unit to
select an item, then press the I or
H buttons to change the setting.
OPTION
OSD
AUTO SEARCH
AUTO SIGNAL
AUTO KEYSTONE
RGB2 SELECT
INPUT
RGB/YP
P
B
R
VGA60/525P
VGA60
BLACKBORD
BACK COLOR
BLUE
NEXT PAGE @
SELECT:[^][@]
ADJUST:[{][}]
OPTION
PREVIOUS PAGE ^
FRONT/REAR
FRONT
DESK/CEILING
DESK
FAN CONTROL
STANDARD
LAMP POWER
LAMP RUN TIME
FUNC1
MUTE
CONTROL KEY
AUTO POWER OFF
SELECT:[^][@]
ADJUST:[{][}]
OSD
ON
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
OFF
Use this setting when you do not
want the current input name to be
displayed.
AUTO SEARCH
ON
The input signal will be detected and
selected automatically when the Input
select (RGB, VIDEO) buttons are
pressed for a few seconds. (page 14)
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OUTPUT
RGB
YP
P
B
R
525P
ON
OFF
BLACK
ESC:[MENU]
REAR
CEILING
HIGH
LOW
HIGH
10 H
KEYSTONE
OFF
ON
DISABLE
ENTER:[ENTER]
ESC:[MENU]
OFF
AUTO SEARCH is disabled.
NOTE:
B AUTO SEARCH will not function
when the input signal is being
projected.
(PT-L735NTU only)
AUTO SEARCH will not function
when NETWORK or SD CARD is
selected. NETWORK and
SD CARD cannot be searched even
when these signals are being input.
AUTO SIGNAL
This should normally be set to "ON".
ON
AUTO SETUP will be carried out
automatically when the input signal
is changed. (page 27)
OFF
AUTO SETUP will not function
when the input signal is changed.
AUTO KEYSTONE
This should normally be set to "ON".
ON
During automatic setup, the angle of
tilt of the projector is detected and
keystone distortion is corrected
automatically.
OFF
Use this setting when you do not
want automatic keystone correction
to be carried out during automatic
setup, such as when the screen
itself is at an angle.
RGB2 SELECT
This setting is used to select the
function of the RGB2 IN/RGB1 OUT
connector.
E
-45
NGLISH
Publicidad
Capítulos
Tabla de contenido
