Mounting Traction Unit To Stand - Chattanooga Triton DTS TRT-600 Manual Del Usuario

SETup

mOuNTiNg TrACTiON uNiT TO STANd

The traction stand is designed for Chattanooga traction units only.
Securement of other traction units need to follow traction
manufacturing recommendations. DJO, LLC is not responsible for
any consequence resulting from using products manufactured by
other companies.
To prevent accidental disengagement, the traction unit must be
securely attached to the mounting surface of the traction stand. It is
the responsibility of the user to verify the adequacy of the
installation before use in patient therapy.
NOTE: The traction unit should be mounted facing the direction of
pull so the Traction Cord does not contact the side of the slot
from which it extends.
14
®
Triton DTS TRT-600 Spine Therapy Table
1. To secure the traction unit to the
traction stand, loosen the
clamp from the traction unit. Fit
the traction unit to the stand and
tighten the clamp up onto the
stand.
2. Attach the mounting screw onto
the traction stand at the front
of the unit. The mounting screw is
provided with traction units only.