If Unit Supplied With Optional Battery; Powering Up The Device - Chattanooga Intelect Mobile 2 Guia De Inicio Rapido

I N T E L E C T ® M O B I L E 2 Q U I C K S TA RT G U I D E
CONNECTING CABLES AND INSERTING
PLUGS
When inserting the plugs, be sure to align the flat side
of the plug with the flat side of the slot and push in
gently� This is to avoid bending the pins in the plug�
Insert cable into the appropriate connector prior to
starting therapy�
INITIAL RECEIPT
Remove all packaging
IF UNIT SUPPLIED WITH OPTIONAL
BATTERY
After unpacking Intelect Mobile 2 to fit the battery
follow the following steps
1� Unscrew the battery cover from the base of the
device by removing the 2 screws see below
2� Remove the battery cover
3� Plug the battery into the battery connector on the
device
4� Insert the battery into its location
5� Replace the 2 screws to close the battery cover
14

POWERING UP THE DEVICE

First time use always use mains power even if battery
connected� Insert the power cord into the back of
the unit, insert the plug into a power outlet, do not
position the Intelect Mobile 2 in such a way that
makes it difficult to disconnect from the mains power�
Switch device on with ON/OFF switch switch on the
back of the unit
1� The Initialisation screen below will be shown for a
few seconds whilst the device starts�
2� The first setup screen will be dispalyed after this
allowing the user to set language, device name,
time and choose patient pain scale as either NRS
(Numerical Rating Scale) or VAS (Visual Analogue
Scale)�
3� Click on "Continue" button to go to home screen