Counter Knife Replacement - JF D Serie Manual Técnico De Operación

OPERATION TECHNICAL MANUAL - MILL 5D - 10D

7.4- Counter knife replacement

If the counterknife (1) is worn, with the edge rounded,
invert it to use the other side.
a) Remove the feeding chute according item ¨a¨ of
previous page.
b) Remove the nuts (2) and then the counterknife (1).
c) Install the new counterknife in position according
illustrated below.
d) Reinstall the feeding chute.
Note: The counterknife with rounded edge cause
misinform cutting, product shredding and power waste.
There after the counterknife assembly check the play
between the knives and impeller, according described on
previous item.
2
1
1
25