Assembling The Machine On The Suport; Assembling The Motor On The Support - JF D Serie Manual Técnico De Operación

OPERATION TECHNICAL MANUAL - MILL 5D - 10D
Rack assembling (5)
a) Assemble both of sliding rails (5) with the bolts +
washers + nuts (5g), just as illustrated aside.
b) Insert the locking pin (5a) in the hole (5j) according
illustrated.
c) Assemble the tightening lever (5b) according illustrated
aside, fastening it with the bolt and nuts (5c).
d) Pulley (5e) and belts (5f) will be described following.
4.2- Assembling the machine on the support
Install the machine on the other side of the support (5) according image aside and fasten it with the
support feet, using the bolts + washers + nuts (5i).
5

4.3- Assembling the motor on the support

IMPORTANT: Check the necessary power of the JF 5D or
JF 10D on the page 10. There you can find the ideal
working speed to each machine model, and the motor
pulley diameter (5d) and the machine (6).
Procedure:
a) Assemble the pulley (5d) which follow the machine,
fastening it with the key.
IMPORTANT: See on page 21 about different speed setup
according pulley diameters.
5j
5h
5g
6
7
5
5d
5a
5b 5c
5i
13