JF D Serie Manual Técnico De Operación página 27

OPERATION TECHNICAL MANUAL - MILL 5D - 10D
Procedure:
a) Remove the feeding chute (2) loosing the bolts (3).
b) Loosen latch (4) and raise the cover (5).
3
2
c) Remove the countercover (6).
5
d) Remove destructively the cotter pin (7) of each one of
the pins (8).
e) Push the pins (8) backward and remove them through
4
the chute assembly outlet (2), taking care for not letting to
fall the hammers (1) and shims (9).
f) Being about the first change of hammers position, to
use the chopper face B of the same ones now (see
previous page).
6
For that, introduce the pins (8) through the outlet of chute
(2) and assemble shims (9) and hammers (1) in an
alternate way, according picture side.
g) Very important: Install a cotter pin (7) on each one of
9
the pins (8).
8
h) Remove the countercover (6).
I) Close cover (5), rising and tighten latch (4).
j) Reinstall the feeding chute (2).
7
1
27