Maintenance; Scheduled Maintenance Table - Clarke RSW 37 Libro De Instrucciones

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
Provided below is the Scheduled Maintenance Table. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance procedures
see the specifi c Service Manual that can be consulted at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary,
the batteries must be disconnected.
Read carefully the instructions in Safety chapter before performing any maintenance procedure.

SCHEDULED MAINTENANCE TABLE

Procedure
WET battery fl uid level check
Side and main broom height check and adjustment
Dust fi lter cleaning and integrity check
Skirt height and operation check
Filter shaker operation check
Hood safety switch operation check
Main broom driving belt visual inspection
Nut and screw tightening check
Service and parking brake check and adjustment
Main broom driving belt replacement
Main motor and drive system motor carbon brush check or replacement
(*) For the relevant procedure, see the Service Manual.
(1) And after the fi rst 8 running-in hours.
14
Every Every
Upon delivery 10
hours hours
Operator's Manual - RSW 37
Every Every Every
50 100 200
hours hours hours
(*)
(*)
(*)
(*) (1)
(*)
(*)
400
(*)