Store Weight Value (Hold); Height Measurements - Seca 763 Manual De Instrucciones Y Garantía

Store weight value (HOLD)

You can also continue displaying the weight determined once the load has been re-
moved. This makes it possible to look after a patient first, before having to note the
weight:
– Press the HOLD/TARE button while
the scales have a weight on it.
– "HOLD" appears in the digital display.
The weight remains stored in the dis-
play until the Hold function is automat-
ically switched off.
– The triangle with the exclamation mark
indicates that this frozen display is an
additional facility which is not subject
to calibration.
– The HOLD function can be switched
off by pressing the HOLD/TARE key
again. appears in the display if the
scales have no load, otherwise the
current weight is shown. The "HOLD"
display vanishes.
Note: The HOLD and TARE functions can also be used simultaneously.

Height measurements

– Press the START button on the dis-
play housing to switch on the device.
First appears in the height dis-
play. The unit selected before switching
off the device is active and is marked by
an arrow.
– If required, switch the unit of height
measurement
height measurement").
– Raise the head slide up and push the
head slide up far enough for the per-
son whose height is being measured
to easily stand under it.
– Ask the person being measured to
place his back against the height rod.
Make sure the person's posture is up-
right and head is straight.
– Now push the head slide down until it
rests on the person's head.
– Note down the height on the display.
Model 763
("Toggling unit of
23