Name Of Each Section And Function; Flush /Tile Mount Type - Ikegami IPD-Q38 Manual De Instrucciones

3. Name of each section and function

3-1. Flush /Tile Mount Type

① ②
③
Side view
① Ethernet
For Ethernet connection. Please connect LAN cable.
It is recommended to use the Cat. (category) 5 or better LAN cable.
② Terminal block
For signal In and Out connections.
The block is standard equipped with the power input (24V), audio output (AUD), microphone
input (MIC), contact output (OUT1) and contact input (IN1) terminals. Four of the AUD, MIC,
IN1, IN2, OUT1 and OUT2 functions may also be optionally selected. You will be charged for
customization.
For details, refer to "Basic Connection (p. 5)" or "System Connection (pp. 7-9)".
* This installation should be made by a qualified service person and should conform to all
local codes.
③ Camera fixing screws
Those are the screws to secure camera installation.
④ INIT switch
This is the switch to go back to the factory settings (Default), when failing in loading of
firmware. (In such a case, Interface software will not go back and IP address should be reset
again) To go back to the factory settings (Default), the return software works only right after
the power ON, therefore, if you want to use this INIT switch for initializing, press and hold the
INIT switch and supply power. And keep pressing it for at least 10 seconds for initializing.
③
④
Under side of metal unit base
E-3