gaviota KYMA Manual De Instalación página 45

Assembly:
Tools required for assembly:
• No. 3, 4, 5, 6 and 8 Allen keys
• Phillips screwdriver
•
Plastic mallet
• Measuring tape
• No. 17 spanner (two units)
Assembly / One Module:
Paso 1. (Type 1 and 2)
•
Motor
Assemble the components on the tube where the canvas is rolled,
Ø78 or Ø85 axis, cut as per Table L. Place the canvas at the indicated
distance, using the round cap as a reference. The plastic bearing is
code 40060879.
•
Gear
In the case of installation with gear, GEL 1:11 120 eye (Code 80010348).
Place the canvas at the indicated distance, using the round cap as a
reference for Ø78 and Ø85 axis.
All dimensions in mm, unless otherwise stated.
Factory assembly
Assembly at the place of installation
Note: For type 1, 2, 3, 4, 5 or 6 configurations, profiles are cut as indicated in Table L.
Example of an installation with motor on the right
KÝMA
40
45