gaviota KYMA Manual De Instalación página 55

FOR TYPE 1 AND 2 CONFIGURATIONS, GO TO STEP 64
Assembly / Two Modules:
(All the example assembly images are a Type 4 configuration with motor to the right).
Step 33. (Type 3, 4, 5 and 6)
Assemble the wall supports, placing them as calculated in Table M.
Step 34. (Type 3, 4, 5 and 6)
Mount the side support to the sides of one of the box profiles (in this example,
the left one). In a motor configuration, install the point side. (If it is a Type 5 or 6
configuration with two motors, it does not matter on which side to start.) Attach
with three DIN7981 4.2x25 self-drilling screws and a Phillips screwdriver.
TIGHTEN THE
SCREWS
DO NOT TIGHTEN
THE SCREWS
All dimensions in mm, unless otherwise stated.
Step 35. (Type 3, 4, 5 and 6)
Mount the joining connector of
the box profile. Insert half-way
in the box profile assembled on
the side support. Tighten the
three DIN913 M6x10 studs with
a no. 3 Allen key
Step 36. (Type 3, 4, 5 and 6)
Introduce the fixing connectors of the arm supports in the box profile groove.
Insert as many units as arms are in the configuration (for a Type 4, two units;
Type 5, depending on where the odd arm is placed, two or three units; Type 6,
three units).
Step 37. (Type 3, 4, 5 and 6)
Assemble the box joint support on one side of the box profile. Introduce the
support connector through the box profile groove on which the connectors
were thread on the prior step. Go to the middle of this support. Tighten
the DIN7991 M8x16 in the groove and leave the other one loose, using a
no. 5 Allen key.
NOTE: We will not use the plastic support in
the case of PVC fabric assembly.
KÝMA
Groove where connectors
are introduced
DO NOT TIGHTEN
TIGHTEN THE
THE SCREW
SCREW
55