gaviota KYMA Manual De Instalación página 48

KÝMA
Step 9. (Common)
Mount the frontal profile which were cut following Table L:
Clip the PVC profile to the aluminium profile, as indicated in the image.
Do not assemble for PVC fabrics.
Step 10. (Type 1 and 2)
Do not assemble for PVC fabrics.
a. Introduce the frontal profile set in the box profile.
48
b. Align the frontal profile set correctly
with the holes of the side supports
as shown in the image.
Step 11. (Common)
Place the connectors introduced in Step 3 at the same distance as the
wall supports. This was previously calculated on Table M. For Type 1, two
connectors; for Type 2, three. Mount the arm supports and join them to
the connectors with two DIN7991 M8x16 screws in each support, with a
no. 5 Allen key.
c. Fix the frontal profile set to the box
sides with two DIN7981 4.2x25 screws
per side with a Phillips screwdriver.
All dimensions in mm, unless otherwise stated.