Faults; Faults With Display - Kärcher BR 45/22 C Manual De Instrucciones

DANGER
Risk of injury. Turn the appliance switch to "0" and pull the mains plug of the
charger prior to performing any work on the appliance.
ATTENTION
Risk of damage for the appliance due to leaking water. Drain the wastewater and
remaining fresh water prior to performing tasks on the appliance.
In case of faults that cannot be remedied using the table below please contact the
customer service.
Display
The brush drive in-
dicator lamp blink-
ing orange
The suction indica-
tor lamp blinking
orange
Batter status dis-
play blinking red
Eco mode indica-
tor lamp blinking
blue
16

Faults with display

Fault
Control is overheated
Brush is blocked.
Control is overheated
Fault during charging
process.
Battery capacity nearly
exhausted, appliance
working at reduced pow-
er.
1 Screw
2 Cover
 Unscrew 2 screws.
 Swivel the lid downwards.
 Loosen and remove the battery plug.
 Remove the left-hand battery.
 Remove the right-hand battery.
 Dispose of the used batteries ac-
cording to the local provisions.

Faults

Remedy
Switch off the power switch, wait a
few minutes, switch on the power
switch again.
Check if foreign matters are block-
ing the brush roller; remove foreign
matter if required.
Switch off the power switch, wait a
few minutes, switch on the power
switch again.
Disconnect the power cord plug of
the charger. Wait for 10 seconds.
Plug in the power cord plug. If the
error message appears again: Call
customer service.
Charge battery.
– 14
EN