Glossary - Honeywell HX 85 Montaje Y Funcionamiento

Glossary

Glossary
Binding
Procedure for assigning the Expan-
sion Module HX 85 to the Homet-
ronic Manager or another device.
Data
Port for data transfer via the X-10
interface.
House code
Specified code for alarm systems
that communicate via the mains
network.
Operating mode
One of two operating modes
(OM 1 and OM 2) that allows both
the processing of signals from
wired sensors as well as X-10
protocol-supported communica-
tion for
HX 80.
68
Priority
Setting of the digital input DI1 or
device address A1. By issuing
priority, alarm messages can be
handled with preference both in
OM 1 and OM 2. The triggering
alarm is not interrupted by activa-
tion of another lifestyle.
Status
State (0 or 1) of a digital input.
State change
State change at a digital input from
0 → 1 or 1 → 0. Change at a device
address from OFF → ON or ON →
OFF.
Sync
Port for synchronisation of the data
transfer via the X-10 interface.
X-10 interface
Interface to ADEMCO alarm sys-
tems (Lynx).