Tabla de contenido
Publicidad
General Safety
• Do not use a power cord adapter
with this equipment.
• Check with a qualified electrician or
service person if the grounding
instructions are not completely
understood or you are in doubt as
to whether the equipment is prop-
erly grounded.
GUIDELINES FOR PREVENTING SKIN
INJECTION
WARNING
!
vent skin injection and other serious
injury, observe the following guide-
lines at all times:
• High pressure spray can inject toxins
into blood stream. If injection
occurs, seek emergency medical
treatment.
• Never try to stop leaks with any part
of your body.
• This system is capable of producing
up to 2000 psi. Use only Campbell
Hausfeld replacement parts speci-
fied for this equipment.
• Never spray without tip guard in
place.
• Do not clean spray tip while it is
attached to the spray gun. Remove
spray tip from gun to clean.
• Never aim or spray at yourself or
anyone else or serious injury could
occur.
WARNING
!
Use a face mask/res-
pirator and protec-
tive clothing when
spraying. Always spray in a well-venti-
lated area to prevent health and fire
hazards. Refer to Material Safety Data
Sheets (MSDS) of spray material for
details.
(Cont.)
SKIN INJECTION
HAZARD: To pre-
GUIDELINES FOR PREVENTING
FIRE/EXPLOSION HAZARDS
WARNING
!
FIRE OR EXPLOSION HAZARD:
To prevent fire or explosion,
observe the following guidelines at all
times.
• Do not use solvents with flash points
o
less than 70
equipment. Examples of acceptable
cleaning solvents include water, min-
eral spirits, and lacquer thinner.
Unacceptable cleaning solvents
include naphtha, MEK, acetone,
alcohol and toluene.
• Do not spray flammable materials in
vicinity of open flame or near igni-
tion sources. Motors, electrical
equipment and controls can cause
electrical arcs that will ignite a flam-
mable gas or vapor. Never store
flammable liquids or gases in the
vicinity of the unit.
• Do not use fuels to clean this equip-
ment.
• Keep spraying area well ventilated.
Keep doors and windows open.
• Remove all ignition sources (e.g., sta-
tic electricity, pilot lights, cigarettes
and electrical arcing).
• Airless spraying can cause static elec-
tricity. Always ground the sprayer
and spraying surface. Always use a 3-
wire grounded extension cord and
power receptacle.
• Do not use solvents containing halo-
genated hydrocarbons.
WARNING
!
als, toxic chemicals, fertilizers, or pesti-
cides. Using these materials could
result in death or serious injury.
3
EZ300 Series
c
o
F (21
) to clean this
Do not spray acids,
corrosive materi-
www.chpower.com
Publicidad
Tabla de contenido
