Set Up The Device; Before You Begin; Prepare The Location - HP Officejet Pro Serie Guía De Instalación Inicial

1 Set up the device

This section summarizes the setup process for the device.

Before you begin

Prepare the location

Make sure the location where you will place the device
meets the following requirements.
• The surface must be sturdy and level.
• Make sure that you leave enough room so that you
can gain access to the back of the device and open
the flatbed scanner lid.
• Do not place the device in direct sunlight or near
chemicals. Make sure that the environment does not
experience abrupt changes in temperature or
humidity.
Temperature
Relative humidity
Set up the device
This section summarizes the steps you follow to set up
the device. For more information, see the setup poster
that came with the device.
NOTE: Check the package contents and install
optional accessories.
2 Set up the device
15° to 35° C (59° to 95° F)
10% to 80%
Remove the tape and packing materials.
1.
NOTE: Be sure to remove the cardboard
packing material from the printhead area.
2. Install the control-panel faceplate.
3. Install the document feeder tray.
Install the ink cartridges.
4.
NOTE: All four ink cartridges must be correctly
installed for the device to work. Ink from the
cartridges is used in the printing process in a
number of different ways, including in the
initialization process, which prepares the device
and cartridges for printing, and in printhead
servicing, which keeps print nozzles clear and
ink flowing smoothly. In addition, some residual
ink is left in the cartridge after it is used. For
more information see www.hp.com/go/
inkusage.
Install the printheads.
5.
CAUTION: Press down firmly on the printheads
to ensure proper contact before closing the
printhead latch.
Connect the power cord and adapter and turn
6.
on the device.
NOTE: Set the language and the country/
region (if needed), as well as the date and time,
on the display.