AKG WMS 4000 Modo De Empleo página 19

2. To select the next Preset, turn the jog switch briefly to the right.
To select the previous Preset, turn the jog switch briefly to the left.
3. Having selected the desired Preset, push the jog switch briefly.
The "GRP" label and the number of the currently active Frequency Group will start flashing.
4. To select the next higher Frequency Group number, turn the jog switch briefly to the right. The high-
est number available will be followed by "00".
To select the next lower Frequency Group number, turn the jog switch briefly to the left. "00" will be
followed by the highest number available.
5. Having selected the desired Frequency Group, push the jog switch briefly.
"CH" and the number of the currently active Subchannel start flashing. Each Subchannel represents
one factory-preset, intermodulation-free carrier frequency.
6. To select the next higher Subchannel number, turn the jog switch briefly to the right. The highest num-
ber available will be followed by "00".
To select the next lower Subchannel number, turn the jog switch briefly to the left. "00" will be followed
by the highest number available.
7. Having finished your settings, push the jog switch briefly. This brings up the following screen:
8a If you want to save the selected carrier frequency, push the jog switch briefly. The setting will be saved
in memory and the display will change as follows:
8b If you'd rather not save the selected frequency, briefly turn the jog switch to the left or right.
This brings up the following screen:
Push the jog switch briefly. The transmitter will stay tuned to the original frequency and the display will
revert to the following screen:
9. To switch the transmitter into LOCK mode:
- Push and hold the ON/OFF button until the message "oFF" appears on the display. After approx. 1/2
second, the display will go dark as power to the transmitter is switched off.
- Switch the transmitter ON in LOCK mode, referring to section 3.4.2.
- To enter SETUP mode:
Push and hold the jog switch until the "LOCK" label disappears and one or more of the readouts in
the current menu start flashing.
3 Setting Up
19