Disassembly; Installation In Explosion Risk Areas; Intrinsic Safety: Atex Ii 1 G Eex Ia Iic T6 - ABB SensyTemp TSP Instrucciones Para La Puesta En Funcionamiento

Installation
3.4

Disassembly

Warning - risk of burns!
Risk of burns caused by leaking dangerous media when disassembling.
Before disassembling the temperature sensor, switch off the process and allow the pipe with
the temperature sensor to cool off.
•
•
•
Caution – Damage to parts!
The connectin cable and housing must not be damaged during deinstallation.
Replace damaged parts.
Note
The EC prototype test certificatePTB 01 ATEX 2200 X, PTB 99 ATEX 1144 and BVS 06 ATEX
E 029 are valid only when original parts are used.
3.5

Installation in explosion risk areas

Caution – Damage to parts!
Avoid temperature increases from heat input or heat accumulation, e.g. through sufficient
distance to hot system parts and thermal isolation, and heat dissipation through unobstructed
air circulation.
The installation and deinstallation may only be performed by specialist personnel who have
knowledge of the concept of the corresponding Ex or ignition-proof types. Compliance with the
Ex temperature classes must be ensured through suitable measures.
The documents belonging to the EC prototype inspection document are explicitly part of these
operating instructions and must be mandatorily complied with.
The temperature sensors must be included in the potential equalization.
3.5.1 Intrinsic safety: ATEX II 1 G EEx ia IIC T6 ... T1, Zone 0, 1, 2
There are no additional specifics that must be observed for the mechanical installation.
8 - EN
The feed lines must be separated before deinstallation of the temperature sensor.
Implement appropriate measures to protect against an unintentional switching on of
opened apparatuses.
The part or apparatus of the system in which the deinstallation is to take place must be
shut down. Ensure that no dangerous media can leak out and that no pressure is
present.
Comply with the relevant safety and accident prevention regulations. In the area of the
Federal Republic of Germany, the operational safety regulations (BetrSichV) must be
observed.
SensyTemp TSP CI/TSP-X1