Mount Downdraft In Cabinet - Thermador Masterpiece Serie Manual De Instalación

I N S T A L L A T I O N
3. Check that markings in cabinet line up with ducting coming
from downdraft.
4. Remove downdraft housing from cabinet.
CAUTION
Before cutting hole in cabinet for ductwork, check for interference
with loor joists, wall studs, electrical wiring or plumbing.
5. Cut ductwork hole in cabinet - as well as holes in wall or loor a necessary.

Mount downdraft in cabinet

1. Set downdraft into cabinet/countertop opening as far back as possible
and make sure it is level.
2. Extend support legs and attach to bottom of cabinet with (2) screws
through each leg. Tighten hex screws.
If cabinet bottom is removed: Use blocks as spacers between loor and
support legs.
3. Extend upper support brackets and attach to sides of cabinet with (2)
screws through each bracket.
Installations using lexible blower only:
FLEXIBLE
BLOWER
4. Extend blower support legs and secure them to bottom of cabinet with
a screw through each bracket. Tighten (4) bolts to secure legs to lex
blower.
(4)
BOLTS
Page 17