Cabinet Installation - Thermador PROFESSIONAL Serie Manual De Instrucciones

14. Install strain relief (not included) into one of the circular
knockouts.
Mounting hood to the wood bracket
15. Before hanging hood, install transition per Figure 3 or
Figure 4. Fasten transition with (2) 3/8'' sheet metal
screws (supplied) and aluminum tape per all applicable
codes.
NOTE: Screws must not hinder damper operation.
16. Using two people to lift, rest the hood on the screws in
the wood bracket. Use the keyholes labeled "F" in
Figure 15. Make sure the wood bracket fits into the
recess on the back of the hood.
F
Figure 15: Location of Screw Holes
17. Tighten the screws in keyholes. Check hood levelness
and adjust if necessary.
Installation Instructions
Figure 14: Strain Relief
J
F
18. From inside the hood, drive 5/8'' (16 mm) screws
through holes in hood into wooden bracket. See holes
labeled "J" in Figure 15.
19. Connect additional ducting.

Cabinet Installation

The hood can be installed under a cabinet by supporting
the hood from the top.
Ensure both knockouts have been removed.
NOTE: The cabinet must be structurally joined to the wall
studs to support the weight of this hood.
Figure 16 shows the (4) keyholes labeled "K" used for
mounting the hood to the bottom of the cabinet.
inches (mm)
59" 59" 59"
(1499) (1499) (1499)
"K" x4 "K" x4
9 9 9
" " "
1 1 1 / / /
16 16 16
(40) (40) (40)
1
"
7 /
16
(179) (179) (179)
Figure 16: Tap Hole and Screw Hole Locations
1. In the base of the cabinet, drill 1/8'' (3 mm) tap holes
59'' (1,499 mm) apart, as indicated in Figure 16.
2. Screw in (4) 1" (25 mm) screws (provided with hood)
leaving 1/4'' (6 mm) exposed to hang the hood on.
"L" x2 "L" x2
L
English | 14 |