Before You Begin; Installation Review; Parts Supplied - Thermador Masterpiece Serie Manual De Instalación

B E F O R E Y O U B E G I N

Installation review

This downdraft system can be used to exhaust cooking by-products
such as heat, steam, and smoke that may be created while cooking
using gas or electric cooktops. With its versatile design, there are ive
(5) basic discharge options - left, right, rear, front and recirculation. It
is important to irst plan your installation. The purchase of additional
accessories to complete the installation may be necessary.
It can be mounted in an island, peninsula, or conventional wall location.
The blower (purchase separately) and electrical panel can be mounted to
the downdraft unit, inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic steps:
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote location.
•
Install the cooking appliance.
•
Install end caps to downdraft.
•
Check the operation.
•
Note: the high level of air low of this appliance may effect the gas
lame on some types of gas cooktops. This is NORMAL and will cause
no harm, but can be corrected by lowering the speed of the blower.
Tools needed
Measuring tape
•
Pencil
•
Phillips screwdriver #2
•
Nut drivers - 11/32" (8.7mm), 3/8" (9.5mm), 7/16" (11.1mm)
•
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves
•
Page 8

Parts supplied

1 Parts Bag containing:
2 - Screws, #8-18
2 - Screws,
x .375 (9.5mm)
1/4-20 x .50
Phillips
(12.7mm) Hex
Head
1 - Plastic
installation
2 - End Cap Trim template
(see pg. 14
2 - 2 in. (51mm)
2 - 4 in. (102mm)
Support Legs
Support Legs
Installation
Use and Care guide
instructions
Downdraft Ventilator Housing
8 - Wood Screws, #10
x .50 (12.7mm) Phillips
Round Head
)
1 - Electrical Panel
2 - Upper Support Brackets
Wiring diagram