Functioning And Instructions For All Models; The Timer Function; Maintenance - Vortice TELENORDIK 5T Folleto De Instrucciones

ENGLISH
7) The remote control receiver box can also be wall
mounted. To do so, drill an 8 mm hole in the wall and
insert the plug provided (fig. 4).
Important
When the remote control is installed, the control box
must be eliminated and the relevant connections
restored.
Install the receiver with the two LEDs facing the part
of the room from which the transmitter will be most
frequently used.
Functioning and instructions for all
models
1) Once you have made all the necessary
connections and fitted the ceiling fan, turn on the
multi-polar switch. The remote control function LED
will come on.
2) Insert two 1.5 V AAA batteries in the battery
compartment in the rear of the transmitter. Respect
the battery polarity as shown.
3) Press the buttons (1 – 2 – 3 – 4 – 5) on the remote
control to test the functioning of the ceiling fan at the
various speeds.
4) Press the light button (marked with the
on the remote control to test turning the light (if fitted)
ON and OFF.
5) Press the "OFF" button on the remote control to
turn the fan OFF. Press the light button (marked with
the symbol) on the remote control to turn the light
OFF again.
Also test all the switches, changeover switches and
push-buttons in the system to ensure that they are
functioning properly.

The timer function

The Telenordik T5 features a timer function that
permits fan operation at the selected speed for one
hour.
To start the timer, simply press the timer button.
The green LED on the receiver lights to show that the
timer has been activated. This LED remains lit for the
duration of the timer function (1 hour) then goes out.
To repeat timed fan operation, press the timer button
again.
You can change fan speed even with the timer active
without affecting fan operation time (which is always 1
hour).
To stop the fan before the end of the timed period,
simply press the OFF button.
Pressing the OFF button deactivates all functions.

Maintenance

Disconnect the appliance from the mains supply
before performing any maintenance operations.
The remote control does not require any particular
maintenance.
Do not use abrasive powders or solvents to clean
visible surfaces.
symbol)
Useful hints
The range of the remote control signal (with fully
charged batteries in the transmitter) is about 13
metres.
If you are installing more than one ceiling fan, leave a
gap of at least 3 metres between one fan and the
next.
If the remote control transmitter fails to operate the
fan, check the transmitter batteries and change them
as necessary. See the note on disposal of batteries in
the Caution section.
11