Publicidad
SeeSnake Micro™
Tools For The Professional
TM
Maximum Distance ..................Optional cable extensions can be assembled
.............................................to make cable up to 30' (762 mm) long
Standard Equipment
The SeeSnake Micro™ comes with the following items:
Imager Head and
Cable
Figure 1 – System Components
Assembly
To Install Batteries (4 AA):
NOTE! Be sure to read Battery Precautions section on Page 2.
1. Turn the hand-held viewer upside down to expose the battery compart-
ment cover and screw (Figure 2).
Battery
Compartment
Cover
Screw
Figure 2
2. Using a Phillips head screwdriver, remove screw and cover.
3. Remove battery compartment and insert four (4) new AA batteries into the
proper slots in the battery compartment (Figure 3). Proper battery orienta-
tion is indicated on the battery compartment.
Hand Held
Display Unit
Accessory Hook
Accessory
Magnet
Accessory
Magnet
Ridge Tool Company
Fin
Figure 3
4. Replace battery compartment, making sure the fin is oriented as shown
with its taller portion toward the LCD screen.
5. Replace battery cover (Figure 2) and screw.
To use the display unit (Figure 1), it must be connected to the imager head
cable.
To connect the cable to the display unit, make sure the keyed ends (Figure 4)
are properly aligned. Once they are aligned, finger tighten the knurled knob to
hold the connection in place.
Keyed ends
Figure 4
To Install an Accessory:
The three included accessories, (mirror, hook and magnet) (Figure 1) all attach
to the imager head the same way.
To connect, hold the imager head as shown in Figure 5.
Slip the semicircle end of the accessory, over the flats of the imager head as
shown in Figure 5. Then rotate the accessory a 1/4 turn so the long arm of the
accessory is extending out as shown in Figure 6.
Figure 5
Figure 6
Battery
Compartment
Accessory
Publicidad
Capítulos
