SHERCO SE 4.5i-f Manual De Propietario página 70

CHECKING CLUTCH HYDRAULIC FLUID LEVEL
Checking the level
- Place the master cylinder horizontally
- Check the level through window.
The level should be between the two
arrows
Adjust the level if necessary
Topping the clutch hydraulic fluid level
- Loosen the two screws
- Remove the cap 2 and its diaphragm
- Fill the reservoir with DOT4 fluid
- Replace the diaphragm, the cap and
the two screws
WARNING
- Hydraulic fluid is highly corrosive
- It can de harmful to the skin.
- Please read the recommendations on
the container.
TIRES
Tire pressure
1. Check the tire pressure on a reguar basis
with an accurate tire pressure gauge.
2. The tire pressure must comply with
the chart shown page 95
Tire wear and damage
1. Check the tire pressure on a reguar
basis with an accurate tire pressure
gauge.
2. If the tread depth is less than 2 mm it
is mandatory that the tire be replaced.
3. Check the tires to make sure that
they do not have any cuts or bulges.
4. If there is a lot of damage to the tires
it is mandatory that you replace them.
68