Indication Of Set Ballistic Curve And Zeroing Range - Leica RANGEMASTER CRF 1600 Manual Del Usaurio

6. Save your setting by briefly pressing the main button.
• The saved setting is lit continuously for 2 s as
confirmation and then disappears.
If a ballistic curve is set, after each range measure-
ment the range value is first displayed for 2 s, then
the calculated holdover for 6 s. This display is made
up of a figure (for centimeters or inches) and or
(for high or low).
Examples:
(for an EU ballistic curve) means that you must
hold 1cm lower to shoot accurately
(for a US ballistic curve) means that you must
hold 4 inches higher to shoot accurately.
INDICATION OF SET BALLISTIC CURVE
AND ZEROING RANGE
If you want to check your settings, e.g. because of
a changed hunting situation or a long time between
uses, you can quickly display the 2 values at any
time.
To do this, briefly press the secondary button twice
when the target mark or the range is displayed.
• Below the target mark (or instead of the range), the
following will appear in turn for around 2s each:
– The set ballistic curve (see p. 30)
– The set zeroing range (see p. 29)
31