SETTING THE UNIT OF MEASURE
The LEICA RANGEMASTER CRF 1600 can be set to
metric units or the Imperial units more commonly
used in the USA, i.e. either meters/Celsius/millibars
or yards/Fahrenheit/PSI (pounds per square inch) for
distance/temperature/atmospheric pressure respec-
tively. This setting also determines the holdover display
(in centimeters or inches) and the available ballistic
curves (see page 148).
Setting:
1. Briefly press the main button (2 / <3 s).
• The target mark appears.
2. Press and hold the secondary button (1 / ≥3 s).
•
appears below the target mark. The display
flashes to indicate that a setting can be made.
Note:
For all settings: The relevant displays disappear 3
seconds after you last press one of the two buttons.
The previously saved settings/values are retained.
3. Briefly press the secondary button twice.
•
appears below the target mark.
4. Briefly press the main button.
•
disappears, and the target mark and
to flash.
5. Select your preferred units of measure by (repeat-
edly) pressing the secondary button,
rial as used in the USA, or
• The relevant displays continue to flash.
Note:
The current setting can always be seen in the display
– if metric values are selected, a dot appears to the
bottom right of the target mark.
6. Save your setting by briefly pressing the main button.
• The saved setting and the target mark light up
continuously for 2 seconds for confirmation and
then disappear.
25
continue
for Impe-
for metric.