Setting The Station Run Time; Master Valve Operation - Irritrol IBOC Plus Guía De Usuario

SETTING THE STATION RUN TIME

A station is assigned to a program when it is given a run time (from one
minute to 23 hours and 59 minutes) in that program. Each station is
limited to one run time assignment per program. However, stations can
be assigned to one, two or three programs and have a different run time
assignment in each.
To set the run time for each station:
1. Turn the function dial to
2. Select Program
3. Press the
(if other than the one displayed).
4. Use the +/
run time minutes (0–59).
5. Press the
6. Use the +/
run time hours (0–23).
Note: The factory setting for each station is "Off." If the station
has a run time and you wish to remove it from this program, use
the +/
ON
7. Repeat steps 3 through 6 to set a run time for each station you
wish to assign to the selected program.
8. Repeat steps 2 through 5 for each program as necessary.
9. When finished, return the function dial to

MASTER VALVE OPERATION

The IBOC Plus enables master valve operation to be selected
independently for each watering program. By default, the master valve
circuit is activated for each watering program.
Note: If a master valve is not installed, its operation must be disabled
to prevent an "Open MV" fault from occurring.
To select master valve operation:
1. Turn the function dial to
2. Select Program
3. Press the
4. Press the +/
master valve for the selected program.
5. Repeat steps 2 through 4 for each program as necessary.
6. When finished, return the function dial to
Programming the Controller
12
STATION WATER TIMES/MASTER VALVE
or with the
,
A B C
button to select the station number you wish to set
NEXT
and/or –/ button(s) to display the desired station
ON OFF
button select hours.
NEXT
and/or –/ button(s) to display the desired station
ON OFF
and/or –/ button(s) to select 0 minutes and 0 hours .
OFF
STATION WATER TIMES/MASTER VALVE
, or with the
A B C
button repeatedly until "Master Valve" is displayed.
NEXT
or –/ button to display the operation of the
ON OFF
button.
PROGRAM
AUTO RUN.
button.
PROGRAM
AUTO RUN.
.
.