Setting Program Start Time; Setting Station Run Time Duration - Irritrol KD2 Guia Del Usuario

Setting Program Start Time

The program start time is the time of day you select to
begin an automatic watering program cycle. When a
program starts, each station with a designated run time
duration in the program will operate in numerical order,
one station at a time. Sometimes it is necessary to run a
watering program more than once per day. For example,
when watering a new lawn. The KD2 provides three
independent start times per day for each program. Refer to
page 8 for additional program start time information
1. Turn the control dial to Start Times
start time being edited will be indicated at the top of
the display. Press the
(1, 2 or 3). The start time symbol will be displayed in the
lower left corner.
2. Press the button as needed to select the desired
program. Program letter A, B or C will be displayed.
3. Set the start time by pressing the
Note: The display will change rapidly if either button is
pressed for more than three consecutive seconds.
• To remove a start time, press the
to display - - - - - - (dashes). The dashes are shown
as the clock display passes from 5:59 AM, 11:59
AM, 5:59 PM and 11:59 PM (05:59, 11:59, 17:59 and
23:59).
4. Press the to advance to the next start time.
5. Repeat steps 1 and 3 for each additional start time.
6. Repeat steps 1–4 for each program as needed.
7. Return the control dial to
finished.
position. The
to select a different start time
or button.
or button
HOME position when

Setting Station Run Time Duration

The station run time duration is the amount of time a
station will operate once it has been started. A station
is assigned to a program when it is given a designated
run time duration ranging from 1 minute to 4 hours. Each
station can have a different run time duration in each
program.
Note: You have the option to view station run time duration
in minutes only or in hours and minutes. By default, the run
time will be displayed in the minutes format; i.e., 1 hour
and 30 minutes is displayed as 90M (minutes). To select
the alternate format, refer to "Station Run Time Duration
Format Option".
1. Turn the control dial to Station Times
The selected station number and the station run time
duration symbol will be displayed.
2. Press the button as needed to select the desired
program. Program letter A, B or C will be displayed.
3. Adjust the station run time duration by pressing the
or button.
• To remove the station from the program, decrease
the run time duration to less than 1 minute to display
- - - - - - (dashes).
4. Press the to advance to the next station.
5. Repeat steps 1 and 3 to set the run time duration for
each station as needed for the selected program.
6. Repeat steps 1–4 for each program as needed.
7. Return the control dial to
finished.
position.
HOME position when
13