Chapter 1. General Description. Technical Characteristics - gala gar GAR CUT 550 Manual Técnico De Instrucciones

CHAPTER 1. GENERAL DESCRIPTION. TECHNICAL CHARACTERISTICS.
The cutting function of the GAR CUT (V.
Profesional) machines is carried out by electric
plasma blown with compressed air. They can cut
all kinds of electricity conductor material: Steel,
stainless steel, aluminium, brass, etc.
Table nº 1 – Maximum cutting thicknesses.
GAR CUT 550.
MAXIMUM
RECOMMENDED
THICKNESS
SOFT STEEL 10 mm.
STAINLESS STEEL 10 mm.
ALUMINIUM 6 mm.
The cutting torch and earth clamp are integrated
in the machine. Therefore, they are not possible to
be separated without disassembling.
The following are supplied with the equipment:
- Cutting torch with direct connection.
- Quick connection earth cable.
- Protection goggles.
FOR THE USE OF ANY OTHER ACCESSORY
CONSULT THE MANUFACTURER.
Fig. 1 – General dimensions of GAR CUT (V. Profesional) equipment.
GAR CUT (V. PROFESSIONAL). Instructions Manual.
LIMIT THICKNESS
12 mm.
12 mm.
7 mm.
This equipment
overheating, lack of pressure in pneumatic circuit,
overloads in the control circuit and contacts with
dangerous voltages during the replacement of
torch head components.
Table no. 2 - Technical characteristics.
TECHNICAL CHARACTERISTICS.
Supply voltage (U –3Ph 50Hz)
1
Maximum primary intensity (I
Primary effective intensity (I
Plasmagen gas
Operating air pressure
Flowrate
Adjustment positions
Torch ignition
Cutting thicknesses up to
Thermal insulation
Ventilation
Protection index.
Weight
Application standards
has protection against:
GAR CUT 550
Ref. 457.00.000
230/400 V
)
33/19 A
1max
)
19/11 A
1eff
AIR
5-5,5 bar
120 l/min
I
28 A (100%)
II
47 A (35%)
H.F.
12 mm
H (180ºC)
FORCED
IP21
67 kg.
EN 60974
13