Chapter 2. Transport And Installation - gala gar GAR CUT 550 Manual Técnico De Instrucciones

CHAPTER 2. TRANSPORT AND INSTALLATION.

Knocks and sudden movements must be avoided
when transporting the equipment. The equipment
will always be transported
packaging must be protected from water.
IF A TRANSPALLET IS USED FOR LIFTING, MAKE
SURE THE EQUIPMENT IS STABLE.
Once the equipment has been unpacked the
base, axle, wheels and handle must be mounted.
Fig. 2. Base, axle, wheels and handle assembly.
2.1 ELECTRICAL INSTALLATION.
The location must
requirements:
- Place: Dry and ventilated, far enough away from
the cutting area in order to prevent the metal dust
caused during the process from getting into the
equipment.
GAR CUT (V. PROFESSIONAL). Instructions Manual.
vertically. The
meet the following
- Electrical installation. Magnetothermal switch.
230 V
25A
Supply hose:
CROSS-SECTION
Length 230 V
10 m 4 mm
>15 m 6 mm
All the equipment of the GAR CUT (V.
Profesional) line have dual-voltage 230-400V.
Therefore it is necessary to check that the voltage
selected on the equipment coincides with the
mains voltage.
The standard equipment leave the factory with
the voltage selector at 400 V, in order to protect it
against negligence in the connection. To change to
230V follow the instructions given in figure 3. (The
procedure will be the same in the event of special
voltages).
Fig. 3. Change of Voltage.
Pos 1
1º. Place screw T in position 2.
2º. To connect the equipment place handle in 230
V. position.
Screw T should always be in place so as to avoid
deterioration in the equipment due to negligence in
the connection.
DO NOT FORGET TO FIT THE EARTH
CONNECTION INTO THE PLUG.
2.2 PNEUMATIC INSTALLATION.
Minimum capacity of the installation: Flowrate
150 l/min – Air pressure 5.5 bar.
The pneumatic intake can be carried out directly
from the compressed air circuit, although it is
recommendable, if the air contains a considerable
amount of humidity or oil, for a gas pre-heater to
be fitted in the input. Thus we will avoid arc
ignition failures as well as premature wear of the
consumable elements (electrode and nozzle).
14
400 V
15A
400 V
2 2,5 mm 2
2 4 mm 2
Pos 2
T