Turkish Bath - Jacuzzi morphosis MEGA Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Turkish bath

Before starting the function, follow the instructions in the chap-
ter "Use of electronic functions - Before starting..."
NB: the activation of this function is conditioned by the num-
ber of "Turkish baths" performed (refer to the chapter on the
anti-scale cycle). Also, it is not possible to use the Turkish bath
if the anti-scale cycle is active.
I Take the dispensers out of their seats, as shown (you can
also press on the lower part); then insert the perfumed sticks,
or a few drops of your favourite essence, and then close the
dispensers, pressing until they are fastened.
A
The single-use packages of perfumed sticks are available from au-
thorized Jacuzzi
®
Service Centres.
It is advisable to cut the stick into two pieces, placing one in
each dispenser (the shower enclosure has two steam outlets,
located on the shelf and on the panel).
I Press the indicated key: the display will show the default
duration for the function (20 minutes) and the LED for the key
will start to flash.
A
A
I After about 2 minutes (the LED will stop flashing and will
turn blue) the water starts to heat; after a very short time,
steam starts coming out of the nozzles.
NB: Condensate might come out of the nozzle; however, this
will stop once the temperature is stable.
I One minute before the end of the set time, there is an
acoustic signal that lets you know you are about to leave the
function, so that you can prolong use (refer to the paragraph
on variation of the temperature of the Turkish bath).
I Once the set time has elapsed, the display will show "00",
and the LED for the key will start flashing.
Do not turn off the main switch until the LED is white, oth-
erwise the boiler will not be washed and drained.
I You can interrupt the function at any time by pressing the
usual key.
24

Publicidad

Tabla de contenido
loading

Tabla de contenido