Alarm - Jacuzzi morphosis MEGA Uso Y Mantenimiento

Scale removal cycle
I Unscrew the cap of the anti-scale nozzle as shown in fig-
ure (1), insert the conveyor provided (2) and pour the liquid
in the opening; then screw the cap back on.
I When the LED stops flashing, the function starts.
I When the 10 hours have elapsed, the boiler cleaning and
draining cycle starts: the LED starts flashing and the display
shows "-SC-".
When the LED that corresponds to the key comes on steady
white, the cycle may be considered complete.
NB: do not turn off the main switch until the anti-scale cycle is
complete, because this would prevent boiler washing.
If the anti-scale cycle is started accidentally, without having
inserted the liquid, you will need to wait 2-3 minutes until the
cycle ends automatically.
If you try to start the Turkish bath during the anti-scale cy-
cle, the message "ACon" will appear flashing for about 3 sec-
onds.
For the entire cleaning cycle, it is normally possible to acti-
vate the alarm and the illumination system, while the date and
time can only be viewed.

Alarm

Connection to the alarm circuit must be made during installation,
by qualified personnel, in compliance with the instructions set forth
in the installation manual.
I When you press the indicated key, the corresponding LED
comes on blue (while the others turn white), and the display
shows the message ALL. Also the alarm signal is immediately
activated (sound signals, buzzers, lights, etc.). This lasts about
15 seconds and then it stops. You can however interrupt it at
any time by pressing the key again.
I The alarm deactivates all electronic operation (if in progress)
except for the illumination on the crosspiece of the shower
box and the anti-scale cycle.
I Press the indicated key during any electronic function to in-
terrupt it, except for illumination of the shower box, even if the
shower box has not been connected to a possible alarm cir-
cuit.
26