Scale Removal Cycle - Jacuzzi morphosis MEGA Uso Y Mantenimiento

Turkish bath
Variation of the time of the Turkish bath
I At any time (with function started) you can change the time
of use of the Turkish bath, from a minimum of 5 minutes to
a maximum of 45:
- To increase the value shown on the display, press the key
(+): each press corresponds to an increase of 1 minute. If the
key is pressed and held, increase is continuous.
- To decrease the value shown on the display, press the key
(—): use the same procedure described above.
NB: the maximum time of use of the Turkish bath also includes
the time already expired at the moment of variation. For ex-
ample, if the has been active for 25 minutes, you can only in-
crease the duration for 20 additional minutes.
In any case, the recommended duration for the Turkish bath
is about 20 minutes. You can choose to enter the shower box
when steam production begins, or after a certain time, when
the temperature and the amount of steam are increased.
Temperature display (only with function active)
ATTENTION! Steam comes out at temperatures of
about 100°C. Keep legs away from the steam outlet
during the steam bath, or at least 40 cm away from the
nozzles.
I The temperature in the shower box
is shown by the "thermometer" icon
on the control panel. This indicator is
divided into three sectors, which come
on progressively as the temperature
increases. When the last sector comes
on, it means that the operating tem-
perature has been reached in the
shower box (see chap. "Notes").

Scale removal cycle

To troubleshoot problems caused by lime scale in the boiler, the
shower enclosure is equipped with a function, which, thanks to the
cleaning action of a specific product, cleans the boiler of any s-
cale deposits.
To guarantee that the boiler is completely cleaned, it is es-
sential to run a scale-removal cycle about once every 20
"steam bath" cycles.
The cycle lasts about 10 hours: during this time, it is possible to
use the "alarm" function but not the steam bath, however, the "wa-
ter jet functions" are still available.
I Make sure the system is active (follow the instructions in the
chapter "Use of electronic functions - Before starting...").
I
Prepare the scale removal mixture as indicated.
I Make sure that the shower enclosure is powered, and hold
down the indicated key for about 3 seconds: the LED begins
to flash, indicating the start of the cleaning cycle.
25