Electrical Requirements; Electrical Shock Hazard; Troubleshooting Problems - KitchenAid KSM7581 Instrucciones Y Recetas

Volts: 120 A.C. only. Hertz: 60
The power rating for your Stand
Mixer is printed on the serial plate.
Do not use an extension cord. If the
power supply cord is too short, have
a qualified electrician or serviceman
install an outlet near the appliance.
The maximum rating is based on the
attachment that draws the greatest
load (power). Other recommended
attachments may draw significantly
less power.

Troubleshooting Problems

Please read the following before
calling your service center.
1. The Stand Mixer may become
warm during use. Under heavy
loads with extended mixing time
periods, you may not be able to
comfortably touch the top of the
Stand Mixer. This is normal.
2. The Stand Mixer may emit a
pungent odor, especially when
new. This is common with electric
motors.
3. If the flat beater hits the bowl,
stop the Stand Mixer. See the
"Beater to Bowl Clearance" section.
Keep a copy of the sales receipt
showing the date of purchase. Proof
of purchase will assure you of in-
warranty service.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
If your Stand Mixer should
malfunction or fail to operate,
please check the following:
- Is the Stand Mixer plugged in?
- Is the fuse in the circuit to the
Stand Mixer in working order?
If you have a circuit breaker box,
be sure the circuit is closed.
- Turn the Stand Mixer off for 10-15
seconds, then turn it back on.
If the mixer still does not start,
allow it to cool for 30 minutes
before turning it back on.
- If the problem is not due to one
of the above items, see the
"Arranging for Service" section.
- Do not return the Stand Mixer to
the retailer, as they do not provide
service.
7