Assembling Your Bowl Lift Mixer - KitchenAid KSM7581 Instrucciones Y Recetas

Assembling Your Bowl Lift Mixer

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
To Attach Bowl
1. Be sure speed control is OFF
and Stand Mixer is unplugged.
2. Place bowl lift lever in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl
until bowl pin snaps into spring
latch.
5. Raise bowl before mixing.
6. Plug into a grounded 3 prong
outlet.
To Raise Bowl
1. Rotate lever to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate lever back and down.
To Remove Bowl
1. Be sure speed control is OFF and
Stand Mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Remove flat beater, wire whip,
or spiral dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
To Attach Flat Beater, Wire Whip, or
PowerKnead™ Spiral Dough Hook
1. Slide speed control to OFF and
unplug.
2. Slip flat beater on beater shaft.
3. Turn beater to right, hooking
beater over the pin on shaft.
4. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater, Wire Whip,
or PowerKnead™ Spiral Dough
Hook
1. Slide speed control to OFF and
unplug.
2. Press beater upward and turn to
the left.
3. Pull beater from beater shaft.
Household Stand Mixer
Speed Control
Plug into a grounded 3 prong outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See the "Speed Control
Guide" section.
Pin
9