Attaching The Flat Beater, Wire Whip And Powerknead™ Spiral Dough Hook; Removing The Flat Beater, Wire Whip And Powerknead™ Spiral Dough Hook - KitchenAid 4KG25H3XWH5 Instrucciones Y Recetas

ASSEMBLING YOUR BOWL - LIFT
Attaching the Flat Beater,
Wire Whip, and PowerKnead™
Spiral Dough Hook
1. Make sure the speed control
lever is set to the OFF/0 position.
2. Unplug the stand mixer or
disconnect power.
3. Slide selected accessory onto
the beater shaft.
..4. Turn the accessory to the right,
hooking it over the pin on the
shaft.
5. Plug into a grounded
3-prong outlet.
STAND MIXER
Removing the Flat Beater,
Wire Whip, and PowerKnead™
Spiral Dough Hook
1. Make sure the speed control
2. Unplug the stand mixer or
3. Press accessory upward and turn
4. To remove, gently slide the
Beater
Shaft
16 16 16 16
lever is set to the OFF/0 position.
disconnect power.
to the left.
accessory down from the
beater shaft.
16