597KL/597KG/599KL/599KG ASSEMBLY INSTRUCTIONS (
7. Set the base/pillar assembly upright. Obtain
the display head module. Plug the load cell
cable into the "SCALE" jack in the back of
the display module.
8. Place the display module on top of the pillar
and align the tab on the front of the pillar
with the slot at the bottom of the display
module.
9. Remove the screw from the back of the
display module, place the module on top of
the pillar and use a Phillips head screw
driver to tighten the module to the pillar with
the screw that was previously removed.
10. Using a Phillips head screwdriver, remove
the 2 screws at the rear bottom of the pillar.
Obtain the AC adapter bracket from the
carton and attach it to the pillar using the 2
screws previously removed. See "Powering
the Scale" on page 13 to insert batteries or
power adapter. Then the scale is ready for
use.
P/N UM597KL_KG 599KL_KG 752KL_KG REV20191121_Web
9
CONT.)
Pillar tab