Cautions And Warnings - Health O Meter 597KL Manual De Instrucciones

CAUTIONS AND WARNINGS

INTENDED USE
This Health o meter® Professional platform scale is intended to be used in a professional medical environment by trained
medical staff. This product was designed to weigh patients who are safely positioned and standing on the platform. If a height
rod is attached to the scale, the intended use of the height rod is to measure patient height. Do not modify the product or use it
for anything other than its intended purpose.
To prevent patient/caregiver injury or damage to your scale, please follow the instructions in this user manual very
carefully.

Do not exceed the weight capacity specified for this scale.

For accurate weighing, this scale must be placed on a flat, stable surface.

For accurate weighing, verify before each use the proper operation according to the procedure described in this manual.

Do not use in the presence of flammable or explosive materials.

If the scale becomes damaged, it should not be operated until properly serviced.

Do not wheel or pull the scale down stairs, doing so may damage internal parts.

Ensure that the AC adapter and scale do not come in contact with liquids, excessive temperature, or excessive
humidity.
Patient/caregiver safety

This scale is designed for static weighing of patients only. No scale should be used for patient transfer.

To prevent patient injury, the patient must be attended throughout the entire weighing event. Caregivers should ensure
that the patient is stable and provide support as needed when getting onto and off of the scale.

Patient should wear socks or other form of lightweight foot covering during weighing event.
When operating the scale with the AC adapter:

Operate this scale exclusively with the AC adapter that is provided (ADPT50). Use of an unspecified adapter will void the
warranty, and can pose a serious safety hazard.

Prior to using this scale, inspect the AC adapter cord for cracking / fraying, or for broken / bent plug prongs.

Prior to using this scale, ensure that the AC adapter is plugged into an outlet with the rated voltage appropriate for
operation.

Ensure that the AC adapter outlet is wired to a circuit breaker or other protected power source.

Unplug the AC adapter, and carefully store both the adapter and adapter cord before moving the scale.

Operating this scale at voltages and frequencies other than specified can damage the equipment and will void the
warranty.
When operating the scale with batteries:

If the scale's display indicates that the batteries are low replace the batteries or switch to the AC adapter as soon as
possible.

When replacing / inserting batteries, be sure to use all new batteries.
This equipment has been tested and found to comply with the EMC limits for the Medical Device Directive 93/42/EEC (EN
55011 Class A and EN 60601-1-2). These limits are designed to provide reasonable protection against harmful interference in
a typical medical installation. The equipment generates, uses and may radiate radio frequency energy and, if not installed and
used in accordance with these instructions, may cause harmful interference to other devices in the vicinity. There is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference with
other devices, which can be determined by turning the equipment off and on, the user is encouraged to try to eliminate the
interference by one or more of the following measures:

Reorient or relocate the receiving device.

Increase the separation between the equipment.

Connect the equipment into an outlet on a circuit different from that to which the other device(s) is connected.

Consult Customer Service or a field service technician for help.
In no event whatsoever shall Pelstar, LLC be liable for damages or injuries whatsoever arising out of or connected
P/N UM597KL_KG 599KL_KG 752KL_KG REV20191121_Web
with the assembly, use, or misuse of its products.
3