Connecting The Drain Line; Connecting The Auto Dosing - LG TCW2013QS1 Manual Del Propietário

14
INSTALLATION INSTRUCTIONS

Connecting the drain line

Secure the drain hose in place to prevent
moving and leaking.
NOTE
• The drain hose should be properly secured.
Failure to properly secure the drain hose
can result in flooding and malfunction.
• Total height of the hose end should not
exceed 96 inches (244.8 cm) from the bot-
tom of the washer.
• The drain must be installed in accordance
with any applicable local codes and regula-
tions.
• Make sure that the water lines are not
stretched, pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow
bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
Elbow Bracket
2
Insert the end of the drain hose into the
standpipe.
3
Use a tie strap to secure the drain hose in
place.
Elbow Bracket
Drain Hose
Using a laundry tub
1
Clip the end of the hose into the elbow
bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold, or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
Elbow Bracket
2
Hang the end of the drain hose over the side
of the laundry tub.
3
Use a tie strap to secure the drain hose in
place.

Connecting the auto dosing

1
Unscrew the 2 screws on the protective
cover.
2
Remove the protective cover.
3
Connect the auto dosing harness from
Accessory parts.
Elbow
Bracket
Laundry Tub
max. 96"
(2.4 m) max. 96"
(2.4 m)
Drain Hose
Tie Strap