Safety Information; Preparing For Use; During Use - koban KM 8212 Manual De Instrucciones

Multímetro tipo lápiz
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety information

Warning
To reduce the risk of fire, electrical
shock, product damage or
personal injury, please follow the
safety instructions described in
the user manual. Read the user´s
manula before using the meter.
This instrument conforms to GB/T
13978-92 for digital multimeter
technical standards, as well as
GB4793. 1-1995 (IEC-61010-1:2001)
safety standards for electronic
measuring instruments with a
safety category of CAT III 600V and
pollution degree of 2.
Follow all safety instructions to
ensure safe use of the instrument.
Following these guidelines will yield
many years of satisfactory service.

Preparing for use

During use, observe all standards
safety rules:
• Use protection to prevent electric
shock.
• Do not misuse the instrument.

During Use

• Always make sure the rotary switch
is at the correct function and
range.
www.grupotemper.com
Pen type multimeter
• Do not exceed the protection limit
values indicated for each function.
• Do not touch test lead tips while
connected to a measurement
circuit.
• In manual range, if the value to be
measured is unknown, select the
highest range first and lower as
needed.
• Do not measure voltages that
may exceed 600V between the
terminals and ground.
• Always be careful whren working
with voltages above 60V DC or 30V
AC RMS. Keep fingers behind the
probe barriers while measuring.
• Never connect the meter leads
across a voltage source while the
rotary switch is in the resistance,
diode or continuity mode. Doing
so can damage the meter.
• Do not perform resistance, diode
and continuiity measurements on
powered circuits.
• Disconnect the test leads from the
circuit before changing functions
on the rotary switch.
• Do not place the meter in an
enviroment with high pressure/
temperature, dust, explosive gas or
vapor.
• Stop using the meter if any
abnormalities or failures occuer.
• Do not connect the test leads to a
circuit without the battery securely
fastened.
• Do not store the meter in an area
of direct sun light.
Instructions manual |
KM 8212
21

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido