Ac Voltage - koban KM 8212 Manual De Instrucciones

KM 8212
Pen type multimeter
Warning
To prevent electric shock and
damage to the meter or personal
injury, do not measure voltages
that may exceed 600V DC.
Note:
• Before connecting the probe and
test lead at lower voltage ranges,
the display may show erratic

AC Voltage

Warning
To prevent electric shock and
damage to the meter or personal
injury, do not measure voltages
that may exceed 600V AC rms.
1. Use the probe cover if making
measurements on category III or
above installations.
Instructions manual | 30
readings. This is normal because
the meter is highly sensitive.
Once a connection is made, the
true reading will be displayed.
• "OL" indicated an over-range
situation in manual mode. A higher
range should be selected.
• In manual mode, select the highest
range first if the value to be
measured is unknown beforehand
and lower as needed.
2. Insert the black test lead into the
COM jack.
3. Turn the rotary switch to the
position.
4. The default mode is DC voltage.
Press FUNC to switch to AC
voltage. Press RAN to switch to
manual range if needed.
5. Connect the test probe and test
lead across the voltage source or
load for measurement.
6. The display will show the measured
value.
www.grupotemper.com