Adjusting The Endstops - CAME Z 24 Serie Manual De Instalación

9 Adjusting the endstops

Adjustments to carry out when
gearmotors are in release
mode: insert the release key
and turn it clockwise.
9.1 - OPENING ENDSTOP - ATI gearmotors
Depending on the function you have assigned to the opening endstop (see paragraph 6.2, page 8) the adjustment settings will be
the following:
Opening Stop
If it intervenes resulting in a Stop,
(default function)
- manually push the door to the fully
opened position;
- release or detach the endstop
and slide it or reposition it until
the switch is activated as
shown in the drawing;
- lock the assembly in this
position.
Opening
However, if it intervenes activating the Decelaration
deceleration
mode,
(option)
- manually push the door to the fully
opened position;
- release or detach the endstop
and slide it or reposition it so
that the switch is adjacent
to the slide as shown in the
drawing;
- lock the assembly in this position.
9.2 - CLOSING ENDSTOP - ATI gearmotors
The closing endstop only activates the deceleration.
Closing To adjust the microswitch,
deceleration
- manually push the gate leaf to the fully
closed position;
- release or detach the endstop
and slide it or reposition it so
that the switch is adjacent
to the slide as shown in the
drawing;
- lock the assembly in this
position.
ATI gearmotors
Screws for fi xing and
locking/releasing the endstops
Microswitch
activating slide
Opening microswitch
Closing microswitch
Switch
Switch
Switch