CAME Z 24 Serie Manual De Instalación página 34

WARNING! Make sure you have inverted the M-N connection for THE RIGHT-HAND MOTOR, as shown on page 6.
Adjustments to carry out when
gearmotors are released: insert
the release handle and turn it
counter-clockwise.
9.3 - OPENING ENDSTOP - FAST gearmotors
Depending on the function you have assigned to the opening endstop (see paragraph 6.2, page 8) the adjustment settings will be the
following:
Opening Stop If it intervenes resulting in a STOP,
(default function)
- manually push the door to the fully opened position;
- release the lower cam and turn it counter clockwise until the switch is
- lock the cam in this position.
Lower cam fi xing and
locking/release screw
Opening
However, if it intervenes activating the Decelaration mode,
deceleration
- manually push the door to the fully opened position;
(option)
- Release the lower cam and turn it counter clockwise until the switch is
released as shown in the fi gure;
- lock the cam in this position.
FAST gearmotors
Lower cam fi xing and
locking/release screw
Upper cam fi xing
and locking/release
screws
activated as shown in the fi gure;
Microswitch
Upper cam
Lower cam
Lower cam
Closing microswitch
(above)
ENDSTOP ASSEMBLY
Opening microswitch
(below)
Switch
Switch