Brake Light Switch Adjustment - Honda NX4 Falcon Manual Del Propietário

Owner´s Manual
Main Fuse
The main fuse (1) is located behind the right side cover.
The specified fuse is: 30 A
1. Remove the seat (page 32).
2. Remove the right side cover (page 33).
3. Disconnect the wire connector (2) of the starter
magnetic switch (3).
4. Pull out the fuse. If the main fuse is blown, install a
new fuse.
The spare main fuse (4) is located under the starter
magnetic switch.
5. Reconnect the wire connector and install the right
side cover.
6. Install the seat.
(3)
(4)
(1) Main fuse
(2)
(2) Wire connector
(3) Starter magnetic switch
(1)
(4) Spare main fuse

Brake Light Switch Adjustment

(Refer to the Safety Precautions on page 43.)
Check the operation of the brake light switch (1) at the
right side behind the engine from time to time.
Adjustment is done by turning the adjusting nut (2).
Turn the nut in the direction (A) if the switch operates
too late and in direction (B) if the switch operates too
soon.
(A)
(B)
(1)
(2)
69
(1) Brake light switch
(2) Adjusting nut