Terms And Conditions Of Warranty - DHC BT701 Procedimiento De La Prueba / Instrucciones De Funcionamiento

What is a SLI battery?
These initials stand for Starting, Lighting and Ignition, which
are the three basic functions which a battery has to perform
on all normal vehicles. Batteries given this description will
have been specifically designed for service on cars and trucks
within a voltage controlled electrical system. Those SLI
batteries which are intended for heavy haulage vehicles fitted
with large diesel motors may often be called COMMERCIAL
batteries. They have to be much more powerful and more
robust than batteries intended for cars.
What is STATE OF HEALTH?
It means how much battery capacity is left (%) comparing
with the marked original battery capacity.
What is STATE OF CHARGE?
It means how many percent of the battery is actually
charged.
What is CCA (COLD CRANKING AMPS)?
The current in amperes which a new fully charged battery
can deliver for 30 seconds continuously without the terminal
voltage falling below 1.2volts per cell, after it has been cooled
O
to 0 F and held at that temperature. This rating reflects the
ability of the battery to deliver engine starting currents under
winter conditions.
What is AMPERE-HOUR?
The unit of measurement of electrical capacity. A current of
one ampere for one hour implies the delivery or receipt of
one ampere-hour of electricity. Current multiplied by time in
hours equals ampere-hours.

TERMS AND CONDITIONS OF WARRANTY

Any battery tester defective in material or workmanship will be
repaired or replaced according to published defective return test
repair procedures. The existence of a defect shall be determined
by the seller in accordance with published procedures. The
- GB.15-V1 -