DHC BT701 Procedimiento De La Prueba / Instrucciones De Funcionamiento página 9

BAD & REPLACE :
The battery will not hold a
charge. It should be replaced
immediately.
BAD CELL & REPLACE :
The battery has at least one
cell short circuit. It should be
replaced immediately.
LOAD ERROR :
The tested battery is bigger
than 2000CCA or 200AH. Or
the clamps are not connected properly.
charge the battery and retest after excluding both
previous reasons.
should be replaced immediately.
12.
Press the
result printing: YES or NO.
Press «ENTER» to confirm
your choice.
24V System Test Printing:
The printer will not function
for 24 Volt batteries system
test printing. The 24V system
test result will be recorded till you hook up to a
12V battery and the right screen shows up. Please
select "YES" and press enter key to print the result
and then disconnect the clamps. The screen will
appear again after you reconnect the clamps.
Please select "NO" and press the enter key to go
back to the main menu.
13.
Press «ENTER» return to step 5 or remove the test
clamps from the battery posts after completion of testing
batteries to end test.
If reading is the same, the battery
key to select
- GB.9-V1 -
BAD & REPLACE
××.××V ×××× SAE
BAD CELL & REPLACE
××.××V ×××× SAE
LOAD ERROR
Please fully
PRINT RESULT?
NO
PRINT 24V SYSTEM
RESULT? YES