American Standard SpaLet Advanced Clean 2.5 Manual De Instrucciones página 12

3. Installation of water supply hose to the SpaLet
Installation
Figure
Water supply
hose
2) Insert the attachment clip onto the
water supply hose to attach it to
®
the SpaLet seat and water supply
connection socket.
* The attachment clip can be attached in
any direction.
3) Bend the clip end and firmly clip
together both the feeding hose for
the SpaLet ® seat and the feeding
socket. After you install the clip,
twist it in both directions to verify
that it is firmly attached, then attach
the final attachment clip over the
primary clip to secure in place.
4) Insert the clip until you feel the clip
edge click.
* If not firmly inserted, it may cause
water leaks
Water supply
joint
Plastic
Clip
Clip
O-ring
12 - EN -
seat
®
1) Connect the water supply hose
for the SpaLet ® seat to the water
supply connection socket.
WATER SUPPLY
CONNECTION SOCKET
Water supply
hose for
the seat
CAUTION
• Be careful not to damage the O-ring.
* A damaged O-ring may cause water to leak.
CAUTION
• Firmly insert the clip.
* If the clip is not fi rmly inserted,
it may cause water leaks.
Water
supply
socket
O-ring