Troubleshooting - American Standard SpaLet Advanced Clean 2.5 Manual De Instrucciones

Troubleshooting

You can easily correct some of the problems with this product. Before requesting repairs, please check the
following items.
If you are unable to correct the problem using the troubleshooting procedures shown below, please contact your
local customer service representative.
All functions
Symptom
The system will not operate
at all.
Back cleansing and Front cleansing
Symptom
Water does not
spray out.
Spray water is not warm.
Heated Toilet Seat
Symptom
The toilet seat is not warm.
Cause
Electricity is not being supplied to
the power outlet.
The power switch is off. The LED
on the indicator panel is off.
The power plug is not plugged into
the wall outlet.
Cause
The water shutoff valve is closed.
The inlet strainer is clogged.
The seat sensor is not engaged.
Water temperature is not set to an
appropriate temperature.
ECO mode is activated.
Cause
Seat temperature is not set to an
appropriate level.
ECO mode is activated.
Check for a power failure or tripped breaker,
etc.
Press the STOP button for 2 seconds to verify
the LED lights on the seat unit light up.
Plug the power plug into the wall outlet.
Turn the water shutoff valve counterclockwise.
Clean the inlet strainer.
Sit back fully on the toilet seat.
Adjust the water temperature to the
appropriate level.
Disable ECO mode.
Adjust the seat temperature to the appropriate
level.
Disable power save.
33 - EN -
Remedy
Remedy
Remedy