Automatic Layout Detection; Black Mark Paper - Oki LD670 Guía De Usuario

6-3-3. Automatic layout detection

The automatic layout settings are configured as follows:

Black mark paper

L1: Length from the vertical reference position to the next reference
Position
L2: Length of the detection area for the vertical reference position
L3: Length from the vertical reference position to the start position
L4: Length from the vertical reference position to the cutting position
L5: Print area length
L6: Length from the left edge of the paper to the left end of the print area
L7: Print area width
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by the driver or utility.
Note: If the paper length (L1) of the loaded roll paper differs by 10% or
more from the initially set paper length (L1) or that set upon
automatic recognition, an error occurs because the type of loaded
roll paper is considered illegal.
(Paper width - L6 x 2) mm (for other paper widths)
L3 L4
Print Area
L6
: Automatically detected
: 5.0mm to 5.5mm
: 1.5mm
: 0.0mm
: (L1 - 1.5 x 2) mm
: 11.0 mm (for a paper width of 83 mm)
: 4.0 mm (for a paper width of 80 mm)
: 3.0 mm (for other paper widths)
: 80.0 mm (for a paper width of 83 mm)
Ｌ5
Ｌ７
61
Base Position
L2
Ｌ１