Beninca PONY Manual De Instrucciones página 15

Laying the foundation plate - Measurements
The positioning of the plate must respect the distances indi-
cated in figures 2a/b/c/d (seen from above):
- Fig. 2a installation with motor on the left
- Fig. 2b installation with motor on the right
If the rack is already installed on the leaf:
- Fig. 2c installation with motor on the left
- Fig. 2d installation with motor on the right
90 mm
50-100 mm
40 mm
50-100 mm
Fig.2a
0-50 mm
90 mm
Fig.2b
Fig.2c
0-50 mm
40 mm
Fig.2d
It is also indispensable that the rack projects, with respect to
the centre of the plate, by at least the measurements indicated
in figure 3a (motor on left) and 3b (motor on right) to allow po-
sitioning of the end run brackets.
In some cases it is possible that the rack projects by a
few centimetres with respect to the plumb line of the
gate in order to allow complete closure.
Make note of the measurements indicated before proceeding
with the successive phases.
The foundation plate has two large holes for the pas-
sage of the raceways. They can both be used, thanks
to the space present on the bottom of the gear motor,
but it is easier to use the hole of the left if the pinion,
highlighted in the figures.
190 mm
Fig.3a
190 mm
150 mm
150 mm
Fig.3b
190 mm
190 mm
150 mm
150 mm
15